top of page




Curved Base for 60" WALNUT GAME Table - Base was constructed with a Curved Frame and covered with Bendable Plywood then FLAT SAWN WALNUT Veneer was applied.

Top has a 1/2" Thick by 2" Wide MAPLE ACCENT Band and the Bottom has a 1/2" Thick by 3-1/2" MAPLE Accent Band.

CHERRY Table Base

Table Base Frame was constructed from Solid Cherry. Legs are 2-1/2" SQ at Top and Taper to 2" SQ at bottom. Stained with a Custom Stain (TOBACCO) and Finished with Three Coats of Sprayed Satin Polyurethane. Granite Top to be provided by Customer.

Price:         $ 850.00

CHERRY Table Base Closeup Details

Connector Rails are 2-1/2" Wide x 1" Thick and were Mortised into the Legs.

Rails were recessed in from the Edge of the Leg approximately 1/4".

Bottom of each Rail has a 1/4" Bead.

All Edges of the Legs have a 3/16" Radius.

42" Drop Leaf Table

Table is 42" Diameter x 30" High and was constructed from ClearPoplar. Legs were splayed out 5 degrees. Top is 1" Thick. Stained with BLACK Analine Dye and Finished with Three coats of Sprayed Semi- Gloss Polyurethane.

Price:         $ 850.00

View of Table Rails

Table Rails are a Mission Style Cloud Design and are 1" thick. Supports for Drop Leaf are Solid Maple and slide Back under the Main section of the Table when not needed.

All Edges have a 3/16" Radius.

Drop Leafs

Drop Leafs are 9" wide (each) and Table Edge has a 3/16" Radus on the Bottom Edge and a Finger Nail edge (slightly recessed) on the Top Edge.

Pine Hall Table w/ Shelf

Table is 42" Long x 14" Deep x 32" High and was constructed from Clear White Pine. There is a full storage shelf approximately 4" above floor level. Finish is Walnut stain with three coats of Sprayed High Gloss Waterborne Polyurethane.

Price:         $ 250.00

Price:         $ 450.00

Maple Hall Table

Table is 42" Long x 34" High x 14-1/2" deep and is constructed from Hard Maple. Stain is Dark Wine Cherry. The Top has a Routed Edge profile and was left Natural to show the figuring in the grain. Legs are tapered on both inside edges. Finish is Four coats of Sprayed water based Semi-glosss Polyurethane.

Maple Hall Table Drawer Pull Closeup

Drawer pulls were made from Tiger Maple and were left clear to show off the graining.

Maple Hall Table Drawer Close-up

Drawer Fronts were made from Curly Maple

Oak Pedestal Table Rebuild

The table was completely taken apart and stripped of old finish and stain. Top was stripped of old Oak Veneer and replaced with new OAK Veneer. Two 12" Leafs were made as well as some replacement parts. Entire Table was restained with Golden Oak and sprayed with four coats of water based semi-gloss polyurethane.

Cost to rebuild: $ 525.00 Cost to make new table $ 1,000.00

Sideview of Completed Oak Pedestal Table Rebuild

All Table hardware was replaced.

10' Farm Table Table is made from Reclaimed Pine Form an old barn. It is 10' Long x 40" Wide x 36" Tall, Stained with Minwax GOLDEN OAK and finished with four coats of Semi-Gloss Marine SPAR Varnish (as this will be under a large Pavillion).

PRICE: $ 2,400.00 - $ 3,000.00

Legs are 4" SQ and Cross Brace is 2" x 3".

Bottom shelf is made from two (2) 7" wide Barn siding boards with the center support post inserted thru them. The boards were notched around the 4" Center Post and rest on cleats attached to the Post. All edges have been eased with a 3/16" Radius.

BAR Table Table is made from Poplar with a custom blend stain to match the original stool stain. Table is 38" High x 12" Deep x 66" Long. The Top has a 5/8" Radius on the Side and Front edges. The Legs are 2-1/4" square and are turned out at the side to mirror the Legs on the stools. The finish is Four Coats of Semi-Gloss Polyurethane

PRICE: $ 500.00 - $ 600.00

Table Frame with one coat of Custom Stain applied. Top Apron and Bottom Rails are Mortised into the Legs.

There is no Bottom Rail on the one side to allow for the Stools to be slid almost under the Table.

Top is attached with screws thru cross supports attached to the Top Apron

Large Breakfast Table for Hotel: Table is constructed from Cabinet Grade 3/4" Birch Plywood with a 3/4" Poplar overlay on Top Edges. Table is 117" Long x 39" Wide 42" High and will have a Granite Top applied. Bottom inset section of each Leg has a Brushed Aluminum plate applied

PRICE: $ 800.00 - $ 900.00

bottom of page