WOODEN-IT-BE-NICE -                   Stephen M. Jornov  -  Owner/Craftsman
All BOXES ARE CUSTOM MADE TO ORDER. THEY ARE MADE TO THE SIZE REQUIREMENTS AS WELL AS THE WOOD(S) DESIRED AND ANY INTERIOR OR EXTERIOR TREATMENT REQUIREMENTS.
 
******************************************************************************
Front View of Wedding Card Box
 
Box is made from Maple, Walnut, Birdeye Maple Veneer and Walnut Veneers and is 13-1/2" Long  x  10-1/2" Wide x 7" High. Top has Three Sections of Birdseye Maple Veneer and Two 7/8*" wide Walnut Veneer Stripes.  Corners are Solid Walnut with Three 3/8" wide Walnut strips inlaid all around the sides of Box . Slot for Wedding Card is 3/8" High  x 10-1/2" long.  Finish is Three coats of Waterbased Polyurethane.
 
Price: $ 250.00  -  $ 400. depending on materials selected
 
Top View of Box
 
Top has Three Section of Birdseye Maple Veneer and Two 7/8*" wide Walnut Veneer Stripes.
 
 
 
 
 
 
Interior View of Box
 
Interior of Box has Two 1/4" Rare Earth Magnets to hold it shut and two decorative Hinges on back.  Hinges stop the lid at 95 degrees.  Interior can have a Liner applied if desired.  Bottom of box has a rubber anti slip pad on each corner.
 
 Box can be made with a slot on opposing sides to hold slats to support a removable tray.  Dividers can also be made for the box as well.  All this can be installed after the box has been used at the wedding so the box has a double useage as a storage box.
 
 
 
 
 
 
 
 
 
 
 
Identification Holder
 
Picture shows a typical setup for the box at a wedding.  Holder can be placed on Top of box (as shown) or in Front of the Box.  Cards are slipped thru the slot
Website Builder provided by  Vistaprint